Autostik Communications
When using USB 2 DB9 serial adapter with the new SC1x10 you will need a Null Modem Adapter installed
This password will give you technician access to program the comm settings.
AS<month><day> 2 digit month and day
Make sure the month and date are what is show on the ATG clock
Related Articles
Incon TS-XXXX ATG Communications Specifics
This applied to all models of Incon TS-XXXX ATGs TS-750, TS-1001, TS-2001 ***IMPORTANT NOTE *** When settings the time on these Incon ATGs, the ATG gets set to programming mode until the time and date are set, then taken out of programming mode. ...
Veeder-Root ATG Communications Specifics
Generally use default serial settings of 9600, 7 , ODD, 1 Veeder-Root Models: TLS-300 - Does not support Line Leak - Only has 1 functioning Serial port (labeled Direct) - Has been known to have that serial port blown since this model has not been ...
MyTankInfo Installation - Step by Step
Outline: 1. Find ATG and verify it has a serial port or is connected to the store's network a. Make sure you have the required serial cable to make the serial connection from the MyTankinfo Device to the ATG if serial or b. You ...
Omntec Specific Information on TLS350 Protocol
Attached is the PDF for serial communications with the Omntec OEL8000III and Proteus. All OEL Models <Ctrl+a>A80 = Request Model Number OEL8000II <Ctrl+a>r02100 = Clear Alarm Log <Ctrl+a>I11100 = Alarm History Report Proteus AKA OEL8000III ...
Simplicity Mode in TLS350
In the late 90's and early 2000's VeederRoot's Fuel Management Service program was called Simplicity. For an ATG to be on this program required that it was programmed to run in a special mode. This "Simplicity" mode caused the ATG to stop ...